Logo

C2655 Engine Trouble Code

Meaning of C2655 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C2655 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for C2655 code is occuring now you should check C2655 repair processes.
Now don't ask yourself; What should you do with C2655 code ?
The solution is here :

C2655 Possible Solution:

C2655 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

C2655 Code Meaning :

C 2 6 5 5
OBD-II Diagnostic Chassis (C) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Fuel Temperature Sensor B Circuit Range/Performance Cylinder 1 Injector Circuit Low Crankshaft Position Sensor B Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C2655 OBD-II Diagnostic Chassis (C) Trouble Code Description

C2655 engine trouble code is about Crankshaft Position Sensor B Circuit Malfunction.

Main reason For C2655 Code

The reason of C2655 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

C2655 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.